ASTi ACE Target - Install ACE Studio 4.5 and Higher

7. Log into the system using the following credentials:
Username Password
admin admin
Note: If your organization changed these default credentials, check with your IT
administrator for an updated username and password.
10.1.2 Install ACEStudio 4.5 and higher
Note: To install ACEStudio on a virtual machine, see the ACE Studio VM Quick Start
Guide.
Before continuing with this installation, complete Section 10.1.1, "Install Red Hat 5.10 and
higher" on page 35. To install ACEStudio versions 4.5 and higher, follow these steps:
1. Log into the system using the following default credentials:
Username Password
root abcd1234
2. Insert the Telestra ASTi Software Installation DVD.
3. From the taskbar, click Applications, point to Accessories, and then click Terminal.
4. To instruct the computer to access the DVD, type mount /dev/dvd /media, and press
Enter.
5. At the prompt, type sh /media/install, and press Enter.
Copyright © 2018 Advanced Simulation Technology inc. 37
ACE Target and Studio Cold Start Guide (Rev. B, Ver. 0)