9. Navigate to Boot, and set the following configurations:
a. Boot Device Priority to the optical drive, hard disk drive, or network
b. Boot to Removable Devices to Disable
c. USB Boot to Disable
10. Navigate to Exit > Exit Saving Changes. At the prompt, select Y.
4.7 BIOS JGIBX10J
To configure BIOS version JGIBX10J, follow these steps:
1. Reboot the development workstation, and immediately press the Delete key as the system
boots to enter the BIOS Setup Utility.
2. When the BIOS Setup Utility opens, press the F9 key to initiate Load Defaults. Select Y
to load BIOS defaults.
3. Navigate to the Main tab, and set the date and time using Greenwich Mean Time.
4. Navigate to Configuration > On-board Drive, and press Enter. Set Serial Port to Dis-
able.
5. Press Esc to return to the Main tab. Navigate to Configuration > SATA Drives, and
press Enter. Set the following configurations:
a. Chipset SATA to IDE
b. S.M.A.R.T. to Enable
c. eSATA Ports to Disable
6. Navigate to the Security tab, and set the following configurations:
a. XD Technology to Enable
b. Intel® Virtualization Technology to Enable
7. Navigate to the Power tab, and set the following configurations:
a. Enhanced Intel SpeedStep® Technology to Enable
b. After Power Failure to Last State
Copyright © 2018 Advanced Simulation Technology inc. 13
ACE Target and Studio Cold Start Guide (Rev. B, Ver. 0)
To Next Page
Loading...