7. Navigate to Chipset > SouthBridge Configuration, and set GbE LAN Boot to
Enabled.
8. Navigate to Exit, and select Exit and Save.
9. Reboot the development workstation, and immediately press the Delete key as the system
boots to enter the BIOS Setup Utility.
10. Navigate to Boot > Boot Device Priority, and set the following configurations:
a. 1st Boot Device to the CD/DVD option
b. 2nd Boot Device to the SATA option
c. 3rd Boot Device to the network option (e.g., IBA GE SLOT DOC8 V1327)
Note: Hardware names and model numbers may vary depending your hardware
type.
d. 4th Boot Device to Disabled
11. Navigate to the Exit tab, and select Save Changes and Exit.
4.4 BIOS Q67AX 2.14.1219 and higher
To configure BIOS Q67AX 2.14.1219 and higher, follow these steps:
1. Reboot the development workstation, and immediately press the Delete key as the system
boots to enter the BIOS Setup Utility.
2. Navigate to the Exit tab, and select Load Optimal Defaults.
3. On the Menu tab, set the System Date and System Time using Greenwich Mean Time.
4. Navigate to Chipset > PCH-IO Configuration, and set the following configurations:
a. Onboard Lan1 Controller to Enabled
b. Onboard Lan2 Device to Enabled
c. Restore AC Power Loss to Power On
5. To return to the Main tab, press Esc. Navigate to Chipset > System Agent (SA) Con-
figuration, and set VT-d to Enabled.
6. To return to the Main tab, press Esc. Navigate to Boot > CSM Parameters, and set
Launch PXE OpROM policy to Legacy only.
7. To save and reset, press the F4 key. A confirmation message requests, "Save con-
figuration and reset?" Select Yes.
Copyright © 2018 Advanced Simulation Technology inc. 9
ACE Target and Studio Cold Start Guide (Rev. B, Ver. 0)
To Next Page
Loading...