8. As the system reboots, press the Delete key to return to the BIOS Setup Utility.
9. To return to the Main tab, press Esc. Navigate to Advanced > CPU Configuration, and
set the following configurations:
a. Hyper-Threading to Disabled
b. Intel Virtalization Technology to Enabled
10. To return to the Main tab, press Esc. Navigate to Advanced > SATA Configuration,
and set SATA Mode Selection to AHCI.
11. To return to the Main tab, press Esc. Navigate to Advanced > SMART Settings, and
set SMART Self Test to Enabled.
12. To return to the Main tab, press Esc. Navigate to Advanced > Super IO Configuration
> Com1 Port Configuration, and set Serial Port to Disabled.
13. To return to the Main tab, press Esc. Navigate to Com2 Port Configuration, and set
Serial Port to Disabled.
14. To return to the Main tab, press Esc. Set CIR Controller to Disabled.
15. To return to the Main tab, press Esc. Navigate to Second Super IO Configuration >
Com3 Port Configuration, and set Serial Port to Disabled.
16. To return to the Main tab, press Esc. Navigate to Com4 Port Configuration, and set
Serial Port to Disabled.
17. To return to the Main tab, press Esc. Navigate to Com5 Port Configuration, and set
Serial Port to Disabled.
18. To return to the Main tab, press Esc. Navigate to Com6 Port Configuration, and set
Serial Port to Disabled.
19. Press Esc twice, and navigate to Third Super IO Configuration > Com7 Port Con-
figuration. Set Serial Port to Disabled.
20. To return to the Main tab, press Esc. Navigate to Com8 Port Configuration, and set
Serial Port to Disabled.
21. To return to the Main tab, press Esc. Navigate to Com9 Port Configuration, and set
Serial Port to Disabled.
22. To return to the Main tab, press Esc. Navigate to Com10 Port Configuration, and set
Serial Port to Disabled.
10 Copyright © 2018 Advanced Simulation Technology inc.
ACE Target and Studio Cold Start Guide (Rev. B, Ver. 0)
To Next Page
Loading...