ASTi ACE Target - Iscsi Cold Start Procedure for Red hat

To Next Page

To Previous Page

8. At the prompt, input the previously recorded interface into the ifconfig ethX command

line, where X is the interface. Verify the settings.

9. (Optional) To configure the IP address and subnet mask, type ace-net-config -a

xxx.xxx.xxx.xxx -n yyy.yyy.yyy.yyy, where xxx.xxx.xxx.xxx is the IP address and

yyy.yyy.yyy.yyy is the netmask.

This configuration sets the IP address and netmask for Eth0, which you can use to access

the Remote Management System (RMS) via a browser to complete the network setup.

10. (Optional) For more network settings, type ace-net-config -h, and press Enter.

11. To activate the changes, type reboot, and press Enter.

Important: If you do not set up Eth0, the system automatically defaults to the DHCP

mode and queries a DHCP server if available for the IP address.

Caution: Do not change the Telestra Target EthX network address to an IP address

that cannot see the iSCSI Target. This mistake may require you to reinstall the soft-

ware.

8.4 iSCSI cold start procedure for Red Hat 6.X

To complete the Telestra iSCSI cold start procedure for Red Hat 6.X, follow these steps:

1. Power on the server using the Power switch on the front of the chassis.

2. Insert the Telestra iSCSI Software Installation DVD, and reboot by pressing the Reset but-

ton on the front of the chassis.

3. At the Boot prompt, press Enter, and wait for initialization to complete.

ACE Target and Studio Cold Start Guide (Rev. B, Ver. 0)