ASTi ACE Target - Install ACE Target Versions 4.13 and Higher

To Next Page

To Previous Page

After the system reboots, the login prompt opens.

Figure 11: Login prompt

7. Log into the system using the following credentials:

Username Password

admin admin

Note: If your organization changed these default credentials, check with your IT

administrator for an updated username and password.

6.1.2 Install ACE Target versions 4.13 and higher

Note: The following steps are for software versions 4.13 and higher. To install older soft-

ware versions, see Appendix B, "Install older software versions" on page51.

Before continuing with this installation, complete Section 6.1, "Installing Red Hat Software (Ver-

sions 4.10 and Higher)" on page 17. To install ACE software versions 4.13 and higher, follow

these steps:

1. Insert the Telestra ASTi Software Installation DVD.

2. Type mount /dev/dvd /media, and press Enter.

Figure 12: Target CDROM mount

3. Next, type sh /media/install, and press Enter.

4. The prompt reads, "Select a product to install." Tab down, and select ACE Target.

5. The prompt reads, "Do you wish to install ACE Target?" Select Yes.

6. Wait for the installation to complete. To eject the DVDfrom the drive, type eject /media,

and press Enter.

7. Remove the DVD from the drive.

ACE Target and Studio Cold Start Guide (Rev. B, Ver. 0)