ASTi ACE Target - BIOS Q67 AX 2.02.1205 and Lower

To Next Page

To Previous Page

23. Press Esc twice, navigate to the Boot tab, and set the Boot Option Priorities as follows:

a. Boot Option #1 to the DVD drive option

b. Boot Option #2 to the hard drive option

c. Boot Option #3 to the network option

Note: Hardware names and model numbers may vary depending your hardware type.

24. Navigate to Boot > Network Device BBS Priorities, and set the following con-

figurations:

a. Boot Option #2 to Disabled

b. Boot Option #3 to Disabled (if present)

c. Boot Option #4 to Disabled (if present)

25. To save and reset, press the F4 key. When the “Save configuration and reset?” con-

firmation message appears, select Yes. Wait as the server reboots.

4.5 BIOS Q67AX 2.02.1205 and lower

To configure BIOS Q67AX 2.02.1205 and lower, follow these steps:

1. Reboot the development workstation, and immediately press the Delete key as the system

boots to enter the BIOS Setup Utility.

2. Navigate to the Main tab, and set the date and time using Greenwich Mean Time.

3. Navigate to the Advanced tab, and set the following configurations:

a. Launch LAN1 PXE OpROM to Enabled

b. Launch LAN2 PXE OpROM to Enabled

4. Navigate to the Save and Exit tab. Select Save Changes and Reset. When the "Save

configuration and reset?" confirmation message appears, select Yes.

5. As the system reboots, press the F2 key to return to the BIOS Setup Utility.

6. Navigate to Advanced > SATA Configuration, and set the following configurations:

a. SATA Mode to IDE Mode

b. Serial-ATA Controller 0 to Enhanced

ACE Target and Studio Cold Start Guide (Rev. B, Ver. 0)