7. Press Esc to return to the Main tab. Navigate to Advanced > CPU Configuration, and
set the following configurations:
a. Hyper-Threading to Disabled
b. Intel Virtualization Technology to Enabled
8. Press Esc to return to the Main tab, and navigate to Chipset > North Bridge. Set VT-d
to Enabled.
4.6 BIOS BLH6710H
To configure BIOS version BLH6710H, follow these steps:
1. Reboot the development workstation, and immediately press the Delete key as the system
boots to enter the BIOS Setup Utility.
2. When the BIOS Setup Utility opens, press the F9 key to Load Defaults. Select Y to load
BIOS defaults.
3. Navigate to the Main tab, and set the date and time using Greenwich Mean Time.
4. Navigate to Configuration > SATA Drives, and press Enter. Set the following con-
figurations:
a. Chipset SATA to Enable
b. Chipset SATA Mode to AHCI
c. S.M.A.R.T. to Enable
d. eSATA Ports to Disable
5. To return to the Configuration menu, press Esc.
6. Navigate to Fan Control & Real-Time Monitoring > CPU Fan, and press Enter. Set
the following configurations:
a. Control Mode to Manual
b. Minimum Duty Cycle to 100
7. Navigate to Security, and set the following configurations:
a. Execute Disable Bit to Enable
b. Intel® Virtualization Technology to Enable
8. Navigate to Power, and set the following configurations:
a. Enhanced Intel SpeedStep® Technology to Enable
b. After Power Failure to Last State
12 Copyright © 2018 Advanced Simulation Technology inc.
ACE Target and Studio Cold Start Guide (Rev. B, Ver. 0)
To Next Page
Loading...