7. When the DVD ejects from the disk drive, remove the DVD. The prompt asks if you
want to check any other media.
Caution: Failure to remove the DVD after verification will completely erase and
reformat the hard disk the next time the system is booted.
8. Repeat Steps 4–7, but replace the applicable Red Hat Installation DVD with the Telestra
Target Software Installation DVD or Telestra Studio Software Installation DVD in Step
4. If DVD verification is successful, proceed with the ACE Target or ACEStudio cold
start procedure.
16 Copyright © 2018 Advanced Simulation Technology inc.
ACE Target and Studio Cold Start Guide (Rev. B, Ver. 0)
To Next Page
Loading...