31
One touch
Continued from previous page
•
Store a signal for switching to temporary
tone dialing. If you have dial pulse (rotary)
service, this signal is required for some
special services. Press [ ] or [ ] until you see
TONE, then press [ENTER]. A T appears on
the screen. All numbers you enter after this
will send touch-tone signals during dialing.
•
You can store the flash signal required by
some special services as part of a dialing
sequence. Press [ ] or [ ] until you see
FLASH, then press [ENTER]. An F appears on
the screen. Continue storing the number as
usual.
•
To erase the last digit, scroll to DELETE
CHAR and then press [ENTER].
-OR-
Press [REMOVE].
•
To copy the most recently dialed number
from redial, press [(AUTO) REDIAL]. You can
copy only the last number dialed from this
extension to a one-touch location. You cannot
copy the other numbers in the redial stack.
•
To cancel programming, scroll to CANCEL
and then press [ENTER].
5. Press the desired one-touch key to store the
telephone number in a location.
-OR-
Press
[LOWER], then the desired one-touch
key to store the telephone number in the lower
location.
6.
To move to the next feature, press [ ].
-OR-
To e
xit, press and hold [ENTER].
PROGRAM
5550100
PAUSE
PROGRAM
5550100
TONE
PROGRAM
5550100
FLASH
PROGRAM
5550100
DELETE CHAR
PROGRAM
5550100
CANCEL
To Next Page
Loading...
