AT&T 1070 Installation Guide

16
Directory card
To write names and/or phone numbers on the directory card, follow the steps
below:
1. Remove the clear plastic cover by inserting a small item such as a paperclip
into the hole on the lower right corner.
2. Pull out the directory card.
3. Write the information on the directory card.
4. Replace the directory card and then the plastic cover.
NOTE: There is a replacement directory card in the telephone package. You
can use it to replace the current one on the telephone if necessary.

AT&T 1070 Specifications

General

Lines Supported	1
Speakerphone	Yes
Caller ID	Yes
Display	LCD
Intercom	Yes
Handset Locator	No
Call Waiting	Yes
Volume Control	Yes
Redial	Yes
Power Source	AC Adapter
Type	Corded