AT&T 1070 - Tone;Pulse; Hold Reminder

36
Phone settings
TONE/PULSE
Use this feature to choose tone (Touch-Tone) or
pulse (Dial-Pulse) dialing. The factory setting is TONE.
Change this to PULSE (rotary) only if you do not
have touch-tone dialing service.
1. Press
[ENTER].
2. Press
[ ] or [ ] until you see PHONE SETTINGS.
Press [ENTER].
3. Press
[ ] or [ ] until you see TONE/PULSE.
4. Press
[ ] or [ ] to choose TONE or PULSE.
5.
To move to the next feature, press [ ].
-OR-
To exit setup,
press and hold [ENTER].
HOLD REMINDER
Use this feature to turn the hold reminder tone on
or off. If you selected ON, when an outside call is
on hold (see the HOLD section on the user’s manual),
a double beep sounds every 30 seconds to remind
you.
1. Press
[ENTER].
2. P
ress [ ] or [ ] until you see PHONE SETTINGS.
Press [ENTER].
3. Press
[ ] or [ ] until you see HOLD REMINDER.
4. Press [ ] or [ ] to choose ON or OFF.
5.
To move to MAIN MENU, press [ ].
-OR-
To e
xit setup, press and hold [ENTER].
PHONE SETTINGS
TONE
TONE/PULSE
PHONE SETTINGS
ON
HOLD REMINDER