AT&T 1070 Installation Guide

39
Special options
Use the following features to customize some
multi-line functions, display settings, Central Office
Voice Mail (COVM) setup, and, for 1070 & 1080
users, caller ID/area code setup.
PRIME LINE
Use this feature, also known as automatic line
selection, to choose which line is automatically
selected each time you lift the handset, press
[ SPEAKER] or [HEADSET] (if a headset is
connected) to make or answer an outside call.
1. Press
[ENTER].
2. Press
[ ] or [ ] until you see SPECIAL OPTIONS.
Press [ENTER].
3. Press
[ ] or [ ] until you see PRIME LINE.
4. Press
[ ] or [ ] to choose the desired line
(LINE 1, LINE 2, LINE 3 or LINE 4).
5.
To move to the next feature, press [ ].
-OR-
To exit setup,
press and hold [ENTER].
AUTOMATIC MODE
Use this feature to choose the mode
(speakerphone or headset) to be used after you
select a line key to make or answer an outside
call, or when you press [INTERCOM] to make or
answer an intercom or voice page call. (See the
Intercom operation section in the user’s manual
for information on the intercom.)
If you lift the handset, the handset mode is used.
1. Press
[ENTER].
2. Press
[ ] or [ ] until you see SPECIAL OPTIONS.
Press [ENTER].
3. Press
[ ] or [ ] until you see AUTOMATIC MODE.
4. Press
[ ] or [ ] to choose SPEAKERPHONE or
HEADSET.
5.
To move to the next feature, press [ ].
-OR-
To exit setup,
press and hold [ENTER].
SPECIAL OPTIONS
LINE 1
PRIME LINE
SPECIAL OPTIONS
SPEAKERPHONE
AUTOMATIC MODE
NOTE: If you select
HEADSET when you
have no headset
connected, and you
press a line key, the
speakerphone is used.

AT&T 1070 Specifications

General

Lines Supported	1
Speakerphone	Yes
Caller ID	Yes
Display	LCD
Intercom	Yes
Handset Locator	No
Call Waiting	Yes
Volume Control	Yes
Redial	Yes
Power Source	AC Adapter
Type	Corded