AT&T 1070 - Csl Delay Ring

75
Centrex
CSL DELAY RING
Set the length of time before this phone routes a
call to the Centrex console phone. One ring cycle
lasts about six seconds.
1. Press
[ENTER] on the desired system telephone
for the Centrex service (except the console
telephone).
2. Press
[ ] or [ ] until you see CENTREX. Press
[ENTER].
3. Press
[ ] or [ ] until you see CSL DELAY RING.
4. Press
[ ] or [ ] to choose the desired delay
time (2–30 seconds). On the console telephone,
choose OFF.
5.
To move to MAIN MENU, press [ ].
-OR-
To exit setup,
press and hold [ENTER].
NOTE: If you want the DTAD to answer calls,
the CSL DELAY RING time should be longer than
the ANSWER DELAY time (page 58) on the same
1080 telephone.
CENTREX
02 SEC
CSL DELAY RING