AT&T DLC-100 User Manual

Testing Your System
Digital Life User Manual | Page 55 of 62 ATT-UM-V1.1-201303
Device Procedure Results Notes
CO Detector
o After alarms have
been observed,
enter your Alarm
Panel PIN to cancel
the alarms and then
enter your Alarm
Panel PIN again to
clear the message
Smoke
Detector
(SW-ATT-
SMK)
• DLS in Test Mode
End-to-End Testing
• Test each device one at
a time by executing the
following procedures
• Press the
TEST/SILENCE button
for ten (10) seconds
• After alarm has been
observed, enter your
Alarm Panel PIN to
cancel the alarm and
then enter your Alarm
Panel PIN again to clear
the message
Local Sensitivity Test
• Press the
TEST/SILENCE button
for four (4) seconds
• Once the test starts, the
smoke alarm LED
flashes one (1) to nine
(9) times
• Count the number of
flashes
• After alarms have been
End-to-End Testing
• For each device
• When smoke is
detected a loud
temporal 3 local alarm
is sounded
• Keypad LCD will display:
<Smoke Device Name> -
Smoke Detected (For
example, “Master
Bedroom – Smoke
Detected”)
• Keypad LCD will display:
Fire Alarm Sent
• Keypad LCD will
Display: Alarm –
Enter PIN to Cancel
• Keypad LCD will
display: Alarm
Canceled
• Keypad LCD will display:
Enter PIN to Clear
Local Sensitivity Test
• Zero (0) to Three (3)
flashes indicates: Have
• A Fire alarm has
been sent to AT&T
Digital Life Central
Monitoring Center
with no action
required

AT&T DLC-100 Specifications

General

Brand	AT&T
Model	DLC-100
Category	Controller
Language	English