AT&T DLC-100 User Manual

Testing Your System
Digital Life User Manual | Page 57 of 62 ATT-UM-V1.1-201303
Device Procedure Results Notes
Functional Testing
NOTE: You can only
execute this test if you
have a glass break
simulator.
• Test each device one at
a time by executing the
following procedures
o Arm the system in the
Armed-STAY Mode
o Activate a glass break
simulator in the area of
the window or
windows that you are
attempting to protect
with the glass break
detector.
o After alarm has been
observed, have
customer enter their
Alarm Panel PIN to
cancel the alarm and
then enter their Alarm
Panel PIN again to
clear the message
Display: Alarm – Enter
PIN to Cancel
• Keypad LCD will display:
Alarm Canceled
• Keypad LCD will display:
Enter PIN to Clear
Keypad and
Siren
(Fire
Emergency)
(SW-ATT-
PAD2W, SW-
ATT-SRN)
• DLS in Test Mode
• Press the FIRE button
on the keypad
• When prompted, press
the asterisk (*) key to
confirm the Fire
Emergency
• After alarms have been
observed, enter your
Alarm Panel PIN to
cancel the alarms and
then enter your Alarm
Panel PIN again to
clear the messages
• Keypad LCD will display:
Press * to Confirm FIRE
• Siren and keypad will
sound a Fire Alarm:
Three (3) short one (1)
second beep sequence
then silence repeating
• Keypad LCD will display:
FIRE Emergency Sent
Keypad LCD will
Display: Alarm – Enter
PIN to Cancel
• A Fire Emergency
alarm has been
sent to AT&T
Digital Life Central
Monitoring Center
with no action
required

AT&T DLC-100 Specifications

General

Brand	AT&T
Model	DLC-100
Category	Controller
Language	English