Atomos SUMO19 User Manual

*Subject to change without notice Atomos Sumo19 – User Manual Edition 1: September 2017 37
LTC
If LTC is selected then Timecode will be taken in via the LTC input (refer
page 12). If no LTC signal is present the following icon is displayed
and the unit will revert to SDI/HDMI Timecode
Please note that the LTC generator needs to be set to the same frame
rate as the input video signal. If the LTC signal is looped through
to the other channel then both recordings will have synchronized
Timecode.
Record Run
WiththissettingyousetthestartingTimecodefortherstclip.The
following clips will start at the frame immediately after the out point of the
preceding clip. This will continue for all clips that follow. This is also
known as continuous Timecode.
Auto Restart
With this setting, the Timecode will be reset to the Timecode you have
denedwheneveryoupressrecord.Allyourclipswillstartwiththissame
Timecode.
To adjust the Timecode use the “+” and “-” above and below the
hour:minute:seconds sections
9. Timecode cont.

Atomos SUMO19 Specifications

General

Product color	Black
Housing material	Aluminum
Video capturing speed	120 fps
Maximum video resolution	3840 x 2160 pixels
DC voltage	16.8 V
Power consumption (typical)	75 W
Built-in display	Yes
Display diagonal	19 \
Display resolution	1920 x 1200 pixels
BNC input ports	1
HDD size	2.5 \

Weight and Dimensions

Depth	63 mm
Width	504 mm
Height	310 mm
Weight	5450 g