MediaPack
Analog Fast Track Guide 42 Document #: LTRT-59805
Safety Notice
1. Installation and service of this gateway must only be performed by authorized, qualified service personnel.
2. To avoid risk of fire use 26 AWG or higher wiring to connect the FXS or FXO telecom ports.
3. The equipment must be connected by service personnel to a socket-outlet with a protective earthing connection.
4. The protective earth terminal on the back of the MP-124 must be permanently connected to protective earth.
Telecommunication Safety
The safety status of each port on the gateway is declared and detailed in the table below:
Ports Safety Status
Ethernet (100 Base-TX) SELV
FXS
TNV-3
FXO
TNV-3
TNV-3: Circuit whose normal operating voltages exceeds the limits for an SELV circuit under normal
operating conditions and on which over voltages from Telecommunication Networks are possible
SELV: Safety extra low voltage circuit.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Notice
This equipment meets the applicable Industry Canada Terminal Equipment technical specifications. This is
confirmed by the registration numbers. The abbreviation, IC, before the registration number signifies that
registration was performed based on a declaration of conformity indicating that Industry Canada technical
specifications were met. It does not imply that Industry Canada approved the equipment.
FXO Ports: The Ringer Equivalence Number (REN) for this terminal is 0.05 The REN assigned to each terminal
equipment provides an indication of the maximum number of terminals allowed to be connected to a telephone
interface. The termination on an interface may consist of any combination of devices subject only to the
requirement that the sum of Ringer Equivalence Number of all devices do not exceed five.
Network Compatibility of FXO Ports
The products support the Telecom networks in EU that comply with TBR21.
http://ArtTel.ru
To Next Page
Loading...
Need help?
General
