Analog Fast Track Guide 8. Regulatory Information
Version 5.0 43 October 2006
ACTA Customer information
1. This equipment, the VoIP Analog Gateway, models MP-118, MP-114 and MP-112 complies with Part 68 of the
FCC Rules and the requirements adopted by the ACTA. On the bottom of the unit of this equipment is a label, that
contains among other information, a product identifier in the format US:AC1IT00BMP11X3AC. If requested, this
number must be provided to the telephone company.
2. This equipment is designed to be connected to the telephone network using an RJ-11C connector, which is Part
68 compliant. The service order code (SOC) is 9.0Y and the Facility interface code (FIC) is 02LS2.
3. The REN is used to determine the number of devices that may be connected to a telephone line. Excessive RENs
on a telephone line may result in the devices not ringing in response to an incoming call. In most but not all areas,
the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a
line, as determined by the total RENs, contact the local telephone company. The REN for this product is part of
the product identifier that has the format US:AC1IT00BMP11X3AC The digits represented by 00 are the REN
without a decimal point.
4. Should the product causes harm to the telephone network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. If advance notice is not practical, you will be notified as
soon as possible. Also, you will be advised of your right to file a compliant with the FCC if it is necessary.
5. The telephone company may make changes in its facilities, equipment, operations or procedures that could affect
the operation of the equipment. If this happens the telephone company will provide advance notice in order for
you to make necessary modifications to maintain uninterrupted service.
6. If trouble is experienced with this equipment, for repair or warranty information please contact AudioCodes Inc.,
2099 Gateway Place, Suite 500, San Jose, CA, 95110, phone number 1-408-441-1175. If the equipment is
causing harm to the telephone network, the telephone company may request to disconnect the equipment until
the problem is resolved.
7. Installation is described in the Product User’s manual. Connection to Telephone Company-provided coin service
is prohibited. Connection to party lines service is subject to State tariffs.
http://ArtTel.ru
To Next Page
Loading...
Need help?
General
