- 46 -
EEPROM INITIAL 1
—— Modify the corresponding print direction in Menu Setup Mode.
—— Adjust the printer’s alignment (see details in Appendix A2).
8. Print the wrong characters.
The communicated transportation of the printer may be incorrect.
—— Check if the connection of the cable is correct or damaged.
Check if the control system of the computer and the data code are consistent with the printer
setting.
—— In the Menu Setup Mode, set the correct emulation according to the requirement.
The printing driver may be incorrect.
—— Please reinstall the printer driver correctly.
9. The printed result is not aligned.
The top of form margin and the bottom margin are not the same.
—— In the Menu Setup Mode, modify the parameter of the TOF ADJUST.
The left margin is not consistent with the right margin.
—— Adjust the paper guide position of the tractor.
—— In the Menu Setup Mode, modify the left and right margins’ parameters.
The tractor paper appears unaligned printing from the second page.
—— Page length setting may be incorrect, modify R.TR PG LGTH in Menu Setup Mode. Reset
the page length and make sure the page length setting is in the computer too.
10. Restore all the settings in the Menu Setup Mode to the factory default settings.
EEPROM Initialization 1 —— Restore the settings to the factory default settings.
[Procedure]:
Press the FORMAT and LF/FF keys and turn on the printer.
The LCD displays as follow, it back to normal display state after initialization.
6.2 How to Solve the Error Message
Error Message Description
HEAD
PROTECTION
The print head is cooling to prevent it from overheating. The ONLINE
light blinks.
The print head becomes too hot during high-density printing. When this
message is displayed, the printing speed is reduced (from bidirectional
printing to unidirectional printing) or printing stops (the print head move
transversely but print nothing). When the print head temperature drops,
the printer restarts printing.
PAPER OUT
Install tractor paper on the tractor and press the EJECT/LOAD key.
Put a cut sheet on the paper rack and load it into the printer.
To Next Page
Loading...
