- 75 -
Caution: Load the paper along the left side (with the “0” mark on the ruler).
A.1.4 Pin test
Power off the printer, press down FORMAT key and turns on the printer, then the printer will print out
a line for you to check whether there is pin broken.
A.2 Adjust Function
A.2.1 Alignment Adjust Mode
Enter the alignment adjust mode to improve the print quality when the printer has been used for a long
time.
Enter method: Press down the ENTER+RLF key and turn on the printer.
LF/FF: Select to adjust the next mode alignment.
HIGH SPEED: Each press on this key, the second line will move left with one step (Value decreased)
EJECT/LOAD: Each press on this key, the second line will move right with one step (Value increased)
ENTER: Save and print.
FORMAT: Press this key to exit the adjust mode, and then the printer will run the initialization.
Note: There are totally 5 adjustments modes (MODE 0~4).
Note: Alignment adjust mode will affect the printing quality, think it over before adjust it and be
strict to the instructions while adjusting.
***** HEXADECIMAL DUMP *****
(0000) 1B 40 A9 A6 29 29 A9 A6 2A 2A A9 A6 2B 2B A9 A6
(0010) 2C 2C A9 A6 2D 2D A9 A6 2E 2E A9 A6 2F 2F A9 A6
(0020) 30 30 A9 A6 31 31 A9 A6 32 32 A9 A6 33 33 A9 A6
(0030) 34 34 A9 A6 35 35 A9 A6 36 36 A9 A6 37 37 A9 A6
To Next Page
Loading...
