35
⚫ This Drive Cycle — displays the status of monitors since the beginning of the current
drive cycle.
4.5.2.3 Live Data
This function displays the real time PID data from the ECU. Displayed data includes
analog and digital input and output, and system status information broadcast in the
vehicle data stream.
Live data can be displayed in various modes. See Live Data for detailed information.
4.5.2.4 On-Board Monitor
This option allows you to view the results of On-Board Monitor tests. The tests are useful
after the service when a vehicle's control module memory is already erased.
4.5.2.5 Component Test
This function enables dual-directional control of the ECM so that the tablet can transmit
control commands to operate the vehicle systems. This function is useful in determining
how well the ECU responds to a command.
4.5.2.6 Vehicle Information
This function enables the display of the vehicle identification number (VIN), calibration
identification number, calibration verification number (CVN), and other information of the
test vehicle.
4.5.2.7 Vehicle Status
This function checks the current condition of the vehicle, such as the communications
protocols of OBDII modules, quantity of fault codes, and the status of the Malfunction
Indicator Light (MIL).
4.6 Diagnostic Reports
4.6.1 Pre-Scan and Post-Scan Functions
After performing pre-scan and post-scan functions by entering the same maintenance
order number, tap Data Manager > Vehicle History to select the historical test record
named with the maintenance order number. Both the pre-scan and post-scan results will
be displayed in the same historical test record, which can be generated as a PDF report
for easy data comparison.
To Next Page
Loading...
