98 AutoFarm GPS AutoSteer
The hydraulic system is always noisy when the engine is running
• Defective SA Module.
• Broken SAM harness
• Bad wheel angle sensor
• Bad calibration. Repeat wheel angle sensor and actuator calibration.
The hydraulic system is always noisy when the engine is
running
• The pump may be stroked up to maximum pressure all the time. Check all hose connections and measure the standby pump
pressure that should be low.
• Oil level may be low.
• Defective pump or hydraulic system. Check vehicle hydraulic system.
• LS Bleed orifice is blocked or was not installed. (only for Power Beyond installations)
To Previous Page
Loading...