Hardware Installation Guide vii
Important Information
Vehicle Requirements
The vehicle steering system and hydraulic system must be in good working order before installing the AutoFarm system.
Check for loose or worn parts. Drive the vehicle before installing the Autofarm system and confirm that it steers straight and
the wheels can be turned from lock to lock. Check the steering system hydraulic hoses and connections to ensure there are no
oil leaks.
The vehicle electrical system and battery must be in good working order.
We recommend that the vehicle be fully cleaned with a high pressure washer before installing the AutoFarm system. A clean
vehicle will facilitate the overall installation and cable routing and will also reduce the chance for oil contamination when the
hoses are opened. It is important to clean the area around the power beyond, front axle, frame, under the cab and behind the
rear cab shields.
Important Information
Note: Tighten all screws, bolts, nuts, hose connections and cable connections after the final assembly of the AutoFarm
Steering System on the vehicle. Follow the checklist at the end of this manual before returning the vehicle to service.
Technical Support
Contact your dealer for technical support.
AutoFarm support can be reached at (U.S./Canada):
Phone: 1-877-947-7327
Contact Information
Novariant, Inc.
45700 Northport Loop East
Fremont, CA 94538, USA
Phone: 1-510-933-4800
Fax: 1-510-933-4801
Web: www.novariant.com
Copyright © 2009 Novariant, Inc. All Rights Reserved.
To Next Page
Loading...