Hardware Installation Guide iii
LEGAL DISCLAIMER
Special Requirements
Tools
This list consists of special tools required to complete the installation. A complete set of common installation tools is assumed.
A workshop may be required for fabricating special brackets as required to fit the AutoFarm system components on specific
vehicle models. Hydraulic hoses must also be fabricated to connect the AutoFarm steering valve to the vehicle.
Allen Hex Key ¼” 11/16” open wrench 16mm open wrench
Allen Hex Key 3/16” 5/8” open wrench 17mm open wrench
Allen Key 5/32” 9/16” open wrench (2x) 18mm open wrench
Allen Hex Key 1/8” ½” open wrench 19mm open wrench
15/16” open wrench 7/16” open wrench 22mm open wrench
7/8” open wrench ½” 12 point ratcheting wrench 24mm open wrench
13/16” open wrench 15/16” socket wrench #1 Phillips Screwdriver
¾” open wrench 13mm open wrench #2 Phillips Screwdriver
Torque wrench Hacksaw with steel cutting blade Portable Drill
Tape measure (12ft minimum) Wire cutter small Cleaning rags
Fiberglass Cable Puller Cleaning brush 5000 psi Pressure Gauge with a Short
Hose and 1/8” Test Port Coupler that
meets the SAE J1502 standard.
Ten Foot Ladder Multimeter
To Next Page
Loading...