Need help?Do you have a question about the AutoFarm A5 and is the answer not in the manual?
Potentially hazardous situations that could result in death or serious injury, or unsafe installation practices.
Potentially hazardous situations that could result in minor to moderate injury or unsafe installation practices.
Step-by-step outline for performing the AutoSteer installation process.
Describes connecting AutoFarm hoses to the Orbitrol and sharing the LS circuit.
Details connecting AutoFarm pressure, tank, and LS hoses to the tractor's power beyond system.
Measures steered wheel position and provides feedback to the GPS steering controller.
Instructions for installing the steering valve using the provided brackets and hardware.
General steps for configuring the valve, installing it, connecting hoses, and performing tests.
Describes installation for vehicles with a closed center non-reacting Orbitrol with a Load Sense line.
Details installation for closed center systems with a power beyond system available.
Detailed instructions for connecting hoses for the closed center power beyond installation.
Procedure for adjusting the built-in Load Sense relief valve on the AutoFarm steering valve.
Checklist to verify all hydraulic installation steps are completed before startup.
Guidelines for positioning and installing the wheel angle sensor to avoid damage and ensure proper function.
Important safety precautions to follow when installing or removing the Roof Module.
Steps for mounting the User Terminal bracket and the terminal itself in the cab.
Instructions for installing the Autosteer warning label on the cab window.
Procedure for calibrating the pressure transducer for accurate manual kick-out response.
Step-by-step guide for initiating the AutoFarm system calibration process.
To Next Page
General