Hardware Installation Guide 57
6
Roof Module Installation
This Roof Module Installation chapter contains information in the following sections:
• Safety Notes
• Roof Module Installation Tasks
Safety Notes
• The AutoFarm system must be powered OFF when installing or removing the Roof Module.
• The supplied locking pin or a padlock must be in place whenever the vehicle is in operation.
• The Roof Module must be removed when transporting the vehicle at speeds above 30 mph.
• Ensure you are in a stable position on the tractor platform when removing the Roof Module, so that you do not fall or drop
the Roof Module.
• Use a ladder to install the roof rail.
• To avoid collisions or electrical shock hazard, remove the AutoFarm roof module from the vehicle before driving under
low structures or low electrical power lines.
Roof Module Installation Tasks
The mounting rail supports the AutoFarm roof module and should be installed over the cab or in another high position with a
clear view of the sky. The mounting rail has several holes and a long slot to accommodate the existing bolt spacing on the cab
roof as shown
Figure 6-1.
WARNING
Ensure that you are in a stable position on the tractor
platform when installing or removing the roof module, so that
you do not fall.
CAUTION
The roof module must be removed when transporting or
driving the vehicle at speeds above 30 mph (50 km/h). The
roof module can possibly detach due to wind loads at
higher speeds.
To Next Page
Loading...