72 AutoFarm GPS AutoSteer
Roof Module Main Harness Connection
Roof Module Main Harness Connection
Attach the Main Cable Harness to the Roof Module.
Route the cable out of the cab towards the roof module See Figure 8-2.
Note: There are usually rubber plugs that can be removed to enable cables to be routed out of the cab. See Figure 8-2.
Note: On cabs that do not provide cabling entry points, it may be necessary to drill a pass through to enable cables to get
through the cab wall. Drill a 1.5 inch or 1.75 inch diameter hole using a hole saw. Install a rubber grommet protect the
cable passing through the hole.
Figure 8-2 Main Harness Exiting the Vehicle Cab
Route the cable up the back of the cab, and attach the cable to the roof module. See Figure 8-3.
To Next Page
Loading...