Autronica AutroSafe Maritime Gas Detection - Page 10

Brief Introduction
System Description and Operation, AutroSafe Maritime Gas Detection, 116-P-BS420MG/XGB, Rev. E, 2019-12-10,
Autronica Fire and Security
Page 4
A typical AutroSafe Maritime Gas System is shown below:
 Fully integrated PowerLoop detectors are connected to the two-
wire PowerLoop, no additional interfaces are required.
 Any 4-20mA devices can be connected to the system’s PowerLoop
by means of the BN-342 4-20mA interface.
 Automatic addressing of detectors – No switch settings required.