Service Commands
System Description and Operation, AutroSafe Maritime Gas Detection, 116-P-BS420MG/XGB, Rev. E, 2019-12-10,
Autronica Fire and Security
Page 64
14.7.1 Upgrade SW
This menu allows you to upgrade the system software version.
Note that before executing this command, the USB memory stick with
the correct and valid system software file must be inserted into one of
the USB ports. After the stick is inserted, wait at least 5 seconds
before executing the command. To view the upgrade status, the View
Upgrade Status command can be used.
The Reboot System command has to be run after an upgrade of the
system.
14.7.2 Upgrade Config
This menu allows you to upgrade the configuration.
Note that before executing this command, the USB memory stick with
the correct and valid configuration file must be inserted into one of the
USB ports. After the stick is inserted, wait at least 5 seconds before
executing the command. To view the upgrade status, the View
Upgrade Status command can be used.
The Reboot System command has to be run after an upgrade of the
system.
14.7.3 Export Config
This menu allows you to export the configuration from the system
panel to the USB memory stick (exported files).
Note that before executing this command, the USB memory stick must
be inserted into one of the USB ports. After the stick is inserted, wait
at least 5 seconds before executing the command. To view the
upgrade status, the View Upgrade Status command can be used.
14.7.4 Export Log
This menu allows you to export the log from the system panel to the
USB memory stick (exported files).
Note that before executing this command, the USB memory stick must
be inserted into one of the USB ports. After the stick is inserted, wait
at least 5 seconds before executing the command. To view the
upgrade status, the View Upgrade Status command can be used.
To Next Page
Loading...