Autronica AutroSafe Maritime Gas Detection User Manual

System Menu
System Description and Operation, AutroSafe Maritime Gas Detection, 116-P-BS420MG/XGB, Rev. E, 2019-12-10,
Autronica Fire and Security
Page 51
13.3 How to Enter Access Level 3 / Set Password
13.3.1 Introduction
This menu describes how to enter/leave Access Level 3 and to set a
new password (requires Access Level 3). All user interface controls
are classified as belonging to one of the four different access levels
described below:
Access
Level
Access Remedy
Description
1
No key or password
required.
Freely accessible. All mandatory indications are visible at
access level 1 without prior manual intervention.
2
Access by key.
Accessible by persons having a specified responsibility for
safety.
3
Password restricted.
Accessible by persons trained and authorized to do
reconfiguration of site specific data and maintenance
according to the manufacturer’s published instruction.
4
Mechanical tool.
Accessible by persons doing repair work and changing
firmware.
13.4 How to Change Language
This menu allows you to determine the language which is to be used
(English / local language) for a panel. A change in language has to be
done locally on each panel.
13.5 How to Initialize the System
The AutroSafe system is automatically initialized when the panel is
turned on. However, in certain cases it may be necessary to manually
initialize the panel.

Autronica AutroSafe Maritime Gas Detection Specifications

General

Brand	Autronica
Model	AutroSafe Maritime Gas Detection
Category	Security System
Language	English