Autronica AutroSafe Maritime Gas Detection - 10.3 Show Status - Alarms; 10.4 Show Status - Alarm Warnings; 10.5 Show Status - Faults; 10.6 Show Status - Disablements

Show Status
System Description and Operation, AutroSafe Maritime Gas Detection, 116-P-BS420MG/XGB, Rev. E, 2019-12-10,
Autronica Fire and Security
Page 41
10.3 Show Status - Alarms
This menu gives detailed information on the current status of fire
alarms in the system. It provides the following information:
 the location
 the exact time of activation
 an identification of the detectors (address)
 the type of detectors (gas detectors)
 all detectors in alarm
 all activated outputs
10.4 Show Status – Alarm Warnings
This menu gives detailed information on the current status of Alarm
Warnings (Prealarms / Early Warnings) in the system. It provides the
following information:
 the location
 the exact time of activation
 an identification of the detectors (address)
 the type of detectors (gas detectors)
 all detectors in Alarm Warning
10.5 Show Status - Faults
This menu gives detailed information on the current status of faults in
the system. It provides the following information:
 the location
 an identification of the address
 the nature of the fault
 a detailed text
10.6 Show Status - Disablements
This menu gives detailed information on the current status of the
disablements in the system. It provides detailed information on the
disablement of the following:
 Detection Zones
 Points (gas detectors)
 Fire Alarm Devices (audible and visual indicators)
 Fire Alarm Routing Equipment (FARE)
 Outputs (FPE)
 Fault Warning Routing Equipment (FWRE)
 Immediate Output Actioning
 All