Terms, Abbreviations/Acronyms and Definitions
System Description and Operation, AutroSafe Maritime Gas Detection, 116-P-BS420MG/XGB, Rev. E, 2019-12-10,
Autronica Fire and Security
Page 2
2. Terms, Abbreviations/Acronyms
and Definitions
The Autronica communication protocol between AutroSafe and
AutroMaster or other third party systems.
The Autronica serial interface and low level protocol for field devices
(loop controllers and power units / AutroSafe).
The Autronica top-level graphical presentation system.
ISEMS: Integrated Safety and Emergency Management System
The system’s local area network.
Logic functions performed in the panel.
Typically used for End of Line resistors for monitoring of
inputs/outputs.
Fault Warning
Routing
Equipment
Intermediate equipment which routes a fault warning signal from (B)
to a fault warning signal receiving station.
Graphical interface for the operator/user.
Fire Protection
Equipment
Fire control or fighting equipment, e.g. extinguishing installation.
The Autronica loop communication protocol for high power gas and
flame detectors. 2-wire loop for both power and communication.
A unit that is directly connected to AutroNet.
Note:
Many terms and abbreviations in this handbook include the
word “Fire” as they refer to EN 54 standards and regulations.
Note that the standard menu structure for fire detection systems
also applies to the Maritime Gas Panel.
The AutroSafe Maritime Gas System only detects gas alarms.
Therefore, disregard the word “Fire” in all contexts.
To Next Page
Loading...
Need help?
General
