Autronica AutroSafe Maritime Gas Detection - Page 12

General Description
System Description and Operation, AutroSafe Maritime Gas Detection, 116-P-BS420MG/XGB, Rev. E, 2019-12-10,
Autronica Fire and Security
Page 6
Using AutroMaster operator stations to monitor different subnets
One or more AutroSafe Gas Alarm Control Panels are located in the
designated area as applicable.
I/O are connected via I/O modules inside the panel or I/O units
mounted on the field loops.
Example of I/O information:
 Cargo Pumps
 Valves
 Dampers
 Doors
 Audible & Visual alarms
The table below shows the key information for the AutroSafe system.
Maximum number of
Standard
System
AutroSafe Maritime Gas panels per system (connected to the local area network;
AutroNet) – BS-420MG/BC4xx
64
Modules per gas alarm control panel / controller
12
Loop units per Powerloop
15
AutroFieldBus units connected to AutroFieldBus
31
Ethernet ports per fire alarm control panel / controller
2
USB host ports per fire alarm control panel / controller
2