Autronica AutroSafe Maritime Gas Detection User Manual

Service Commands
System Description and Operation, AutroSafe Maritime Gas Detection, 116-P-BS420MG/XGB, Rev. E, 2019-12-10,
Autronica Fire and Security
Page 56
The test signal is given the lowest priority. In the event of an alarm,
the alarm signal will thus override the test signal.
14.3.2.4 Manual Test ON- Fault Warning Routing Equipment (FWRE)
The test is similar to the test for Fire Alarm Devices (audible and
visual indicators) and it requires Access Level 3 (password restricted).
For detailed description, refer to 14.3.2.2.
When the test is initiated, a test signal will be sent to all Fault Warning
Routing Equipment (FWRE) within the Operation Zone (if there are
several Operation Zones, the signal will be sent to FARE in all
Operation Zones). The duration of the signal and the interval between
each signal are configurable (normally 1 second ON and 30 seconds
OFF).
The test signal is given the lowest priority. In the event of an alarm,
the alarm signal will thus override the test signal.
14.3.2.5 Manual Test ON - Other Outputs
This chapter describes how to test other outputs. The test requires
Access Level 3 (password restricted).
When the test is initiated, a test signal will be sent.
14.3.2.6 Manual Test OFF
The subsequent chapters describe how to terminate an ongoing test
for
 Fire Alarm Devices (audible and visual indicators)
 Fire Alarm Routing Equipment (FARE)
 Fault Warning Routing Equipment (FWRE)
 Other Outputs
NOTE:
Before this test is performed, make sure that all extinguishers
(or other similar equipment) that are to be tested are
disconnected. During the test, use a measuring instrument to
measure the output on the Fire Protection Equipment that is to
be tested.

Autronica AutroSafe Maritime Gas Detection Specifications

General

Brand	Autronica
Model	AutroSafe Maritime Gas Detection
Category	Security System
Language	English