Display Keys
2420 User Guide Page 31
IP Office 3.0(DT) 40DHB0002USEG Issue 3d (16th March 2005)
Longhand Programming
1. Press Admin or Admin 1. See Display Key Programming. .
2. Pressing Expl?
to switch to longhand programming mode.
3. Press Next
until the required function required is shown, then press Selct .
4. If the function requires some data to be entered, [ is shown at the bottom of the display. Enter the
data using the normal telephone keypad.
5. The upper part of the display reverts to showing the functions currently assigned to each
and
key.
6. Use the
and keys to move between the pages of display keys.
7. Select the display key against which to program the new function by pressing that
or key.
• Do not select the slot used for the Admin function. Replacing this function will lock the
phone for further programming until reset through the telephone system.
8. If the display slot is not already used, the display shows BUTTON PROGRAMMED!. Press the
or
keys until EXIT is shown.
• Press EXIT to end programming.
• Press Cont to continue programming other functions.
9. If the display slot already has a programmed function, the display shows FEATURE ON
BUTTON. Press the
or keys until Repla, Keep and Delet are shown along the right-hand
edge of the display.
• Press Repla to replace that existing function with the one just programmed. The
display then shows BUTTON PROGRAMMED! as above.
• Press Keep to keep the existing function and forget the function just programmed.
• Press Delete to delete the existing function and forget the function just programmed.
To Next Page
Loading...
