2420 User Guide
2420 User Guide Page 44
IP Office 3.0(DT) 40DHB0002USEG Issue 3d (16th March 2005)
HGEna - Hunt Group Enable
Sets the extension's membership of a group or groups as enabled.
This function can be programmed with or without a target group number. This function cannot be
programmed through the phone by the user.
If programmed without a group number, pressing
HGEna toggles all the extension's group
memberships to either enabled or disabled. A
is shown next to HGEna when the group
memberships are enabled.
If programmed with a group number, that number is shown next to
HGEna. Pressing HGEna will
enable the extension's membership of that group. In this mode the key does not toggle.
When enabled, G is shown on the display and the extension will receive group calls.
• [User | Digital Telephony | Advanced | Hunt Group | Hunt Group Enable]
HGDis - Hunt Group Disable
Sets the extension's group membership as disabled.
This function can be programmed with or without a target group number. This function cannot be
programmed through the phone by the user.
If programmed without a group number, pressing
HGDis disables all the extension's group
memberships.
If programmed with a group number, pressing
HGDis disables just the extension's membership of
that group.
[User | Digital Telephony | Advanced | Hunt Group | Hunt Group Disable]
HGNS+ - Set Hunt Group Night Service (!)
Put a specific hunt group into night service mode.
This function requires the hunt group number to be entered when programmed. The hunt group number
is then shown next to HGNS+. This function can be programmed through the phone by the user using an
Admin key.
Pressing
HGNS+ puts the hunt group into night service. Group calls then go to its night service
fallback group if set or, if not answered, to voicemail.
[User | Digital Telephony | Advanced | Set | Set Hunt Group In Service]
HGNS- - Clear Hunt Group Night Service
Returns a hunt group that has been manually put into night service back to normal service.
This function requires that the hunt group number is entered when programmed. This function cannot be
programmed through the phone by the user.
The hunt group number is shown next HGNS-. Pressing
HGNS- puts the group back into normal
service if in night service.
[User | Digital Telephony | Advanced | Call | Clear Hunt Group Night Service]
To Next Page
Loading...
