Display Keys
2420 User Guide Page 35
IP Office 3.0(DT) 40DHB0002USEG Issue 3d (16th March 2005)
BusyH - Busy On Held
Switch the users busy on held status on/off.
This function requires data entered when programmed. Enter either 0 for off or 1 for on. This function
cannot be programmed through the phone by the user.
Pressing
BusyH switches the user's 'busy on held' state to either on or off as indicated by the data
value. When on, if the users has a call on hold, new callers receive busy tone (ringing if analogue) or are
diverted to voicemail if enabled, rather than ringing the user. This also overrides call waiting indication
when the user has a call on hold.
This function is not supported via 2420 display keys.
• [User | Digital Telephony | Advanced | Busy | Busy On Held]
CFrwd - Call Forwarding All (!)
Switch call forwarding on/off and set the forwarding number.
This function can be programmed with or without a target forwarding number. This function can be
programmed through the phone by the user using an
Admin key.
If programmed with a forwarding number, that number is shown next to CFrwd. Pressing CFrwd
switches on forwarding to that number.
If programmed without a forwarding number, when
CFrwd is pressed, the user's current forwarding
number setting is shown. Change the number using the telephone keypad and <<<
to backspace.
When the number set as required press Done
.
When call forwarding is on, CFrwd is shown with a
symbol and D (Diverted) is shown at the top of the
display. To switch call forwarding off, press
CFrwd again.
• [User | Digital Telephony | Emulation | Call Forwarding All]
See also:
• FwNOn - Forward On No Answer On.
• FwUOn - Forward Unconditional On.
• FwdNo - Forward Number.
• FwdH+ - Forward Hunt Group Calls On.
ClrCW - Clear CW
Clears the current connected call and connects any waiting call.
This function does not require any data entered when programmed. This function cannot be
programmed through the phone by the user.
Pressing
ClrCW disconnects the extension's current call and connects any waiting call.
• [User | Digital Telephony | Advanced | Call | Clear CW]
CnfRV - Conference Meet Me
Allows the extension to join a specified conference.
This function requires the conference number to be entered when programmed. That number is then
shown next to CnfRV. This function cannot be programmed through the phone by the user.
Pressing
CnfRV places the extension into the specified conference. Note that the number of
conference parties allowed at any time is determined by the telephone system.
• [User | Digital Telephony | Advanced | Call | Conference Meet Me]
To Next Page
Loading...
