Display Keys
2420 User Guide Page 39
IP Office 3.0(DT) 40DHB0002USEG Issue 3d (16th March 2005)
DNDX+ - Do Not Disturb Exception Add
Adds the specified number to the extension's do not disturb exception list.
This function requires entry of the calling number when programmed. That number is then shown next to
DNDX+. This function cannot be programmed through the phone by the user.
Pressing
DNDX+ adds the set number to the extension's do not disturb exception list. That number
can then call the extension and transfer calls to the extension even when the extension is in do not
disturb mode.
• [User | Digital Telephony | Advanced | Do Not Disturb | Do Not Disturb
Exception Add]
DNDX- - Do Not Disturb Exception Delete
Removes the specified number from the extension's do not disturb exception list.
This function requires entry of the calling number when programmed. That number is then shown next to
DNDX-. This function cannot be programmed through the phone by the user.
Pressing
DNDX- adds the set number to the extension's do not disturb exception list. That number
can then call the extension and transfer calls to the extension even when the extension is in do not
disturb mode.
• [User | Digital Telephony | Advanced | Do Not Disturb | Do Not Disturb
Exception Del]
DPkUp - Directed Call Pickup (!)
Answer a call currently ringing at a specified user or group.
This function can be programmed with or without a the target extension or group number. This function
can be programmed through the phone by the user using an
Admin key.
If programmed with a target number, the
DPkUp key displays that number. When a call is ringing at
that extension or group, press
DPkUp to answer (pick up) that call.
If programmed without a target number, pressing
DPkUp allows the user to enter the target number
for that pickup attempt.
• [User | Digital Telephony | Emulation | Directed Call Pickup]
Drop - Drop (!)
Clears a current calls. Temporarily pauses the ringing of an incoming call.
This function does not require any data entered when programmed. This function can be programmed
through the phone by the user using an
Admin key.
For an incoming call ringing the extension, pressing
Drop switches off the ringing for a few seconds
before ringing again. Note: If the timers for forwarding or diversion to voicemail expire during the silent
period, those actions will occur without the call ringing at the extension again.
For a call in progress, pressing
Drop disconnects the caller.
When drop is used, silence is returned to the user rather than dial tone. This is intended operation,
reflecting that Drop is mainly used by call center headset users.
• [User | Digital Telephony | Emulation | Drop]
To Next Page
Loading...
