8. Disconnect the G430 power cable from the mains power supply.
9. Disconnect the G430 power cable from the G430.
10. Unscrew the top cover screw, and remove the Branch Gateway cover.
11. Move the bridge on jumper J3801 to its initial position, in which the two pins closest to the
rear of the G430 are bridged.
Important:
If you do not move the bridge on jumper J3801 to its initial position, the Branch Gateway
will continue to initialize the NVRAM when it resets or is powered up.
12. Replace the Branch Gateway cover.
Troubleshooting
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 110
Comments on this document? infodev@avaya.com
To Next Page
