4. At the Linux prompt, type mv <firmware_filename> /tftpboot, and press Enter to
move the firmware file to the /tftpboot directory.
To move multiple firmware files (most firmware files have an .bin suffix; the media module
firmware files have a .fdl suffix), use the command mv *.bin /tftpboot or mv *.fdl /
tftpboot. The Linux prompt reappears. The firmware file has been moved to the /tftpboot
directory. If you copy the firmware using the cp command, remove the files from the /var/
home/ftp/pub directory after you have copied them.
5. Repeat step
4 on page 94, if necessary, for each firmware file you want to install.
6. At the Linux prompt, type cd /tftpboot.
The Linux prompt reappears. The current directory has changed to /tftpboot.
7. At the Linux prompt, type ls, and press Enter.
A list of files in the directory appears.
8. Check the directory to make sure the firmware files you want to install are listed.
Related links
Installing firmware from the TFTP server on the S8300 Server on page 93
Upgrading Branch Gateway firmware using the CLI via a USB
device
About this task
You can upgrade firmware via a USB mass storage device using the CLI. The upgrade files must
first be downloaded to a local PC.
Procedure
1. Prepare installation worksheets.
See
Preparing installation worksheets on page 90.
2. Download the firmware files to a PC.
See Downloading Branch Gateway firmware files to a local PC on page 95.
3. Insert a USB mass storage device into the PC’s USB port, and copy the firmware files to the
USB mass storage device.
4. Remove the USB mass storage device from the PC, and insert it into the Branch Gateway
USB port.
5. Run CLI commands to copy the firmware files from the USB mass storage device to the
Branch Gateway.
See
CLI commands for upgrading Branch Gateway firmware via a USB device on page 95.
Upgrading the Branch Gateway firmware
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 94
Comments on this document? infodev@avaya.com
To Next Page
