Chapter 3: Connecting devices
Connecting devices
External endpoint devices can be connected to the ports on the front panels of the installed media
modules and to the fixed front panel ports. Before you connect endpoint devices, the Branch
Gateway, and EM200s if desired, should be mounted and all media modules should be inserted.
Warning:
To reduce the risk of fire, use only 26 AWG or larger telecommunication line cords when
installing telephones or adjuncts, or connecting to any media module telecommunication ports.
Related links
Roadmap for connecting devices on page 43
Data and voice device connections on page 44
Circuit protection installation on page 52
Connecting an E1/T1 WAN link to the MM340 media module on page 53
Coupled Bonding Conductor installations on page 54
Avaya Partner Contact Closure Adjunct installations on page 54
Roadmap for connecting devices
Connect these devices in the following order using the appropriate procedure described in this
section:
1. Data and voice devices
2. Circuit protection
3. Wide Area Network (WAN)
4. Coupled Bonding Conductor (CBC)
5. Avaya Partner Contact Closure Adjunct
Related links
Connecting devices on page 43
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 43
Comments on this document? infodev@avaya.com
To Next Page
