Chapter 6: After installation
After installation
After initial configuration, it is necessary to test the installation, and remove the installation
equipment.
Related links
Roadmap for post installation on page 63
Installation testing on page 63
Removing the installation equipment on page 66
Roadmap for post installation
Perform these post-installation procedures tin the following order using the appropriate procedure
described in this section:
1. Test the installation
2. Remove the installation equipment
Related links
After installation on page 63
Installation testing
When the installation is complete, you must perform simple tests to verify telephone and data
connectivity.
Related links
After installation on page 63
Testing data connectivity on page 64
Testing telephones on page 64
Testing trunks on page 64
Testing LSP failover on page 64
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 63
Comments on this document? infodev@avaya.com
To Next Page
Loading...
