• Slot and port number on the Branch Gateway to which the telephone connects — this does not
apply to IP telephones.
Related links
Configuration of telephones on Communication Manager on page 69
Testing the telephone
Procedure
1. Make outgoing calls from the telephone.
Make sure you hear a dial tone when you pick up the receiver. Make sure you can make
both an internal (within the local network) and an external (outside of the local network) call.
2. Make a call to the telephone from both within the network and outside of the network.
Related links
Telephone additions on page 69
Trunk additions
You must order, connect, configure, and test the trunk before adding the trunk to the Branch
Gateway.
Related links
Media module and device additions on page 68
Trunk ordering on page 70
Trunk ordering
• Make sure that the telephone service provider installs the trunk near the physical location of the
Branch Gateway and verifies that the trunk is working properly before you contact the
technician who is performing or supervising the configuration
• Note the telephone number of the trunk
Related links
Trunk additions on page 70
Special considerations when ordering an analog trunk on page 70
Special considerations when ordering an analog trunk
When you order an analog trunk, there are several recommendations depending on your system’s
particular needs:
• For optimal functioning of the MM714B Emergency Transfer Relay feature, it is recommended
to use a loop-start trunk
• For access to voice mail systems in the United States, it is recommended to use a ground start
trunk to ensure that calls are properly disconnected when the outside caller disconnects.
- Ground start trunks may be provided via the MM711, MM714B or MM714 media modules.
Adding media modules and devices
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 70
Comments on this document? infodev@avaya.com
To Next Page
