Avaya G430 - Firmware Specifications

removable ground even when the AC cords are disconnected. However, because of unreliable
earthing concerns in Finland, Norway, and Sweden, the Branch Gateway must be installed in a
Restricted Access Location (RAL). An RAL is defined as an access that can be gained only by
trained service personnel or customers who have been instructed about the reasons for the
restricted access and any safety precautions that must be taken. In these cases, access to the
Branch Gateway is gained by the use of a tool (such as a lock and key) or other means of
security. If you have any questions about the safety conditions, contact your project manager.
When you have verified that the site is ready for a safe installation, proceed with the installation.
Related links
Site requirements on page 15
Firmware Specifications
New Comcode numbers for G430
Old codes will still be active for G430 with imbedded MP20 and MP80 bundle option.
• 700503274 : G430 120 channel DSP daughter board – Single MP120 for upgrades
• 700506957 : G430 MP120 Media Gateway – New bundle no on board MP20 and preinstalled
MP120
• 700506958 : G430 MP120 Media Gateway Non-GSA – New bundle number on board MP20
and preinstalled MP120
• 700508198 : G430 120 CHANNEL DSP daughter board
Minimum firmware requirements for G430
v1a
v2a
(MP120
Preinstalled)
Comments Recommended CM Version
- Older versions of CM will
work
BGW 5.0 27.31.0 Yes No CM 5.0 (SP)
BGW 5.1 28.27.0 Yes No CM 5.1 (SP)
BGW 5.2 29.24.0 Yes No No BGW support
MP120
CM 5.2 (SP)
BGW 5.2.1 30.28.0 Yes No No BGW support
MP120
CM 5.2.1(SP 16) or higher
(CM blocks more than 105
channels)
BGW 6.1 31.26.0 Yes No No BGW support
MP120
CM 6.0.1
(CM blocks more than 105
channels)
BGW 6.2.1 32.26.0 Yes No No BGW support
MP120
AA 6.2 FP1 CM 6.2 sp 4 — Dec
2012
Table continues…
Before you install
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 17
Comments on this document? infodev@avaya.com