Avaya G430 - Removing the Installation Equipment

Result
Note:
See also “Auto Fallback for H.248 Gateways” in Administering Network Connectivity on Avaya
Aura
®
™
Communication Manager, 555-233-504 and the Migrate H.248 MG to primary" screen
command in Avaya Aura
®
™
Communication Manager Screen Reference, 03-602878.
Related links
Installation testing on page 63
IP addresses and controllers on page 66
IP addresses and controllers
Primary media gateway
controller
IP addresses to configure
S8300 The IP address of the primary S8300
S8400 The IP address of the S8400’s C-LAN or the IP address of an Ethernet port
on the S8400 configured for processor Ethernet connections
S8500 The IP address of the S8500’s C-LAN or the IP address of an Ethernet port
on the S8500 configured for processor Ethernet connections
S8510 The IP address of the S8510’s C-LAN or the IP address of an Ethernet port
on the S8510 configured for processor Ethernet connections
1
The IP address of the S8700’s C-LAN and the IP address of alternate C-LAN
boards connected to the S8700 (Server A LAN, Server B LAN)
S8710 The IP address of the S8710’s C-LAN and the IP address of alternate C-LAN
boards connected to the S8710
S8720 The IP address of the S8720’s C-LAN and the IP address of alternate C-LAN
boards connected to the S8720
S8730 The IP address of the S8730’s C-LAN and the IP address of alternate C-LAN
boards connected to the S8730
Related links
Testing LSP failover on page 64
Removing the installation equipment
About this task
Remove all equipment that you used to assist you in the installation process. This may include the
CD-ROM drive, the software upgrade CDs, the laptop computer, and the modem (for installations
without an S8300X module only).
1
After installation
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 66
Comments on this document? infodev@avaya.com