Avaya G430 - Firmware Upgrades from the Primary Controller; Upgrading Firmware Using the CLI through FTP;TFTP

Related links
Branch Gateway firmware upgrades on page 87
Firmware upgrades from the primary controller
For a Branch Gateway without an S8300 or for a Branch Gateway with an S8300 installed as an
LSP, you can upgrade Branch Gateway firmware from the remotely located primary controller. The
primary controller may be an S8300, S85XX, S87XX, or S88XX server. See the guide for the
primary controller for information about upgrading firmware from the primary controller. See
Upgrading, Migrating, and Converting Avaya Servers and Gateways, 03-300412.
Note:
You can only upgrade using FTP on the S85XX, S87XX, and S88XX servers.
Related links
Branch Gateway firmware upgrades on page 87
Upgrading firmware using the CLI through FTP/TFTP
About this task
You can upgrade firmware through FTP/TFTP using the CLI. You can perform the upgrade remotely
using a modem connection, but the upgrade files must first be downloaded to an FTP or TFTP
server on the LAN connected to the Branch Gateway.
Procedure
1. Prepare installation worksheets.
See
Preparing installation worksheets on page 90.
2. Set up an FTP or TFTP server on the LAN connected to the Branch Gateway.
For information about setting up a TFTP server, see Setting up a TFTP server on page 91.
Note:
If you use an FTP server, the Branch Gateway prompts you for a username and
password when you enter a command to transfer a file. Also, when opening an FTP
connection to the S8300, all anonymous FTP file transfers are restricted to the /var/
home/ftp/pub directory. Permission for anonymous FTP users to create files in other
directories is denied. You must enable the S8300 FTP server from the Maintenance web
page. The S8300 FTP server disables itself after 15 minutes.
3. Download the firmware files to the FTP or TFTP server.
See `z
Downloading Branch Gateway firmware files to a local TFTP server on page 91 or
Installing firmware from the TFTP server on the S8300 Server on page 93.
4. Connect to the Branch Gateway via modem or via the Services port on the front panel.
Upgrading the Branch Gateway firmware
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 88
Comments on this document? infodev@avaya.com