For information about connecting the Branch Gateway to the Services port, see Connecting
a computer to the Services port. For information about connecting and enabling a modem for
remote access, see Chapter 4: Connecting and enabling a modem for remote access on
page 56.
5. Run CLI commands.
See
CLI commands for upgrading Branch Gateway firmware via FTP/TFTP on page 89.
Related links
Branch Gateway firmware upgrades on page 87
CLI commands for upgrading Branch Gateway firmware via FTP/TFTP on page 89
Example upgrade via FTP/TFTP using the CLI on page 90
Installation worksheets on page 90
TFTP server setup on page 91
Downloading Branch Gateway firmware files to a local TFTP server on page 91
Installing firmware from the TFTP server on the S8300 Server on page 93
CLI commands for upgrading Branch Gateway firmware via FTP/TFTP
You can use CLI commands to upload an upgrade file to the Branch Gateway. For each of these
commands, include the full path of the file and the IP address of the FTP or TFTP host as
parameters. You must use the specific path to the file on the FTP or TFTP server according to the
home directory of the service (FTP or TFTP) that you are using. When you enter the command, the
CLI prompts you for a username and password.
• Use the copy ftp EW_archive command to upgrade the Java applet for Avaya Gxxx
Manager software from an FTP server
• Use the copy ftp module command, followed by the module number of the module you
want to upgrade, to upgrade the firmware on a media module from an FTP server
• Use the copy ftp SW_imageA command to upgrade the Branch Gateway firmware into
Bank A from an FTP server
• Use the copy ftp SW_imageB command to upgrade the Branch Gateway firmware into
Bank B from an FTP server
• Use the copy tftp EW_archive command to upgrade the Java applet for Avaya Branch
Gateway Manager software from a TFTP server
• Use the copy tftp module command, followed by the module number of the module you
want to upgrade, to upgrade the firmware on a media module from a TFTP server
• Use the copy tftp SW_imageA command to upgrade the Branch Gateway firmware into
Bank A from a TFTP server
• Use the copy tftp SW_imageB command to upgrade the Branch Gateway firmware into
Bank B from a TFTP server
Related links
Upgrading firmware using the CLI through FTP/TFTP on page 88
Branch Gateway firmware upgrades
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 89
Comments on this document? infodev@avaya.com
To Next Page
Loading...
