Avaya G430 - Page 90

Example upgrade via FTP/TFTP using the CLI
To upgrade the firmware of an MM712 media module in slot 3 from a TFTP server with the IP
address 192.1.1.10, where the home directory is c:\home\ftp\ and the upgrade file is located in the
directory c:\home\ftp\version, use the following command:
copy tftp module \version\mm712v51.fdl 192.1.1.10 3
Note:
When uploading firmware from the S8300, use only the file name, without the directory path, in
the command line. Otherwise, the procedure will fail. For instance, in the example above, you
must use the following command: copy tftp module mm712v51.fdl 192.1.1.10 3
Note:
When uploading firmware from the S8300 using TFTP, you may need to enable TFTP service in
the Set LAN Security parameters of your web server.
The following example uploads a firmware version with the path and file name
C:\gxxx.net from an
FTP server with the IP address 149.49.134.153 to Bank A of the Branch Gateway:
copy ftp SW_imageA C:\gxxx.net 149.49.134.153
Related links
Upgrading firmware using the CLI through FTP/TFTP on page 88
Installation worksheets
Before you perform the upgrade, you must enter the names of the target software and firmware
versions that you need to install in the software and firmware upgrade worksheet. If you will need to
set up a TFTP server, you also need to plan the TFTP server IP address, login, and password.
Related links
Upgrading firmware using the CLI through FTP/TFTP on page 88
Server Values worksheet on page 90
TFTP Server worksheet on page 91
Server Values worksheet
Table 8: Software and firmware upgrade file names
Items for Upgrading
New file name for target
File for LSP and primary controller (not used for individual
files)
Branch Gateway Processor
Branch Gateway Device Manager
MM710 E1/T1 media module
Table continues…
Upgrading the Branch Gateway firmware
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 90
Comments on this document? infodev@avaya.com