Avaya G430 - Mounting the EM200 Expansion Module(S); EM200 Installation

Procedure
1. Remove the four feet from their packaging.
2. Turn the Branch Gateway upside down.
3. Position each foot into one of the mounting sites, near each corner of the chassis.
Related links
Branch Gateway installations on page 21
Mounting the EM200 expansion module(s)
About this task
You can optionally extend the G430 by attaching one or two EM200 expansion modules to the
G430. Since the cables attaching the EM200 expansion modules to the G430 are short, you must
install the Branch Gateway and EM200s directly above or below each other.
The EM200 expansion modules can be mounted in a rack or on a table, similarly to how the Branch
Gateway is mounted. Refer to
Mounting the Branch Gateway chassis on page 21. Note that
although the figures illustrating the mounting instructions depict a Branch Gateway, all rack and
table mounting procedures apply equally to both the G430 and the EM200. Keep in mind the
following:
Procedure
If you are mounting the Branch Gateway and EM200 module(s) on a table, always place the G430
on top of the EM200(s).
This enables easy access in case you need to open the G430 cover in order to add or replace a
DSP module or the RAM card.
Result
Note:
You cannot mount a G430 with EM200 modules on a wall.
Related links
EM200 installation on page 27
EM200 installation
If you mounted one or two EM200 modules for the purpose of expanding the Branch Gateway,
connect each EM200 to the G430 using the expansion cable supplied with each EM200.
• If you mounted one EM200:
1. Connect one end of the expansion cable to the CONNECTOR OUT 1 connector on the
rear of the G430.
Mounting the EM200 expansion module(s)
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 27
Comments on this document? infodev@avaya.com